Prioritizing the Cutting Settings of the Printer Driver (or CutStudio/VersaWorks)

The cutting settings of the printer driver (or CutStudio/VersaWorks) can be prioritized over the operation panel settings.
Procedure
  1. Press [TOOL SELECT].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] several times to display the screen shown below.

    MENU_TOOL_SetCmd
  3. Press [ENTER].
  4. Press [▲] or [▼] to select "Accept setup command".
    The cutting conditions set with the printer driver (or CutStudio/VersaWorks) will be prioritized over the operation panel settings.
    oeb1610610679310_Source
  5. Press [ENTER] to confirm your entry.
  6. Press [ON/OFF LINE] to go back to the original screen.
    MEMO Default setting: "Accept setup command"