Performing Perforated Cutting for All Cutting Lines

You can use all cutting lines sent to the cutting machine for perforated cutting. Select this method to use all cutting data for perforated cutting rather than changing some cutting data to perforated lines.
Procedure
  1. Press [MISC].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] several times to display the screen shown below.
    The current setting is displayed.

    MENU_MISC_DieKissC

  3. If "Die/Kiss Cut" is "OFF", press [▲] or [▼] to switch "Die/Kiss Cut" to "ON".
  4. Press [ENTER].
  5. Set the cutting lengths for "Die Cut" and "Kiss Cut".

    MENU_DieKissC_Length

    1. Press [◀] to select "Die Cut". Press [▶] to select "Kiss Cut".
    2. Press [▲] or [▼] to change the value.
  6. Press [ENTER].
  7. Set the blade forces for "Die Cut" and "Kiss Cut" on the following screen.

    MENU_DieKissC_Force

    1. Press [◀] to select "Die Cut". Press [▶] to select "Kiss Cut".
    2. Press [▲] or [▼] to change the value.
  8. Press [ENTER].
  9. Press [ON/OFF LINE] to go back to the original screen.
    MEMO Default setting: "OFF"

    Cutting length setting range (Die Cut/Kiss Cut): 0.1 to 100 mm/0.1 to 100 mm (changeable in 0.1 mm increments)

    Blade force setting range (Die Cut/Kiss Cut): 5 to 600 gf/5 to 600 gf (changeable in 5 gf increments)