Turning the Power Off

WARNING

Remove any loaded media or switch off the sub power when printing is not being performed.

The continued application of heat at a single location may cause the release of toxic gases from the media or pose a fire hazard.

Procedure
  1. Switch off the sub power whenever printing is finished.
    Hold down the sub power switch for 1 second or longer.

    ER-642_Subpower-ON

  2. Raise the loading lever and remove the media.
    • When not using the machine, raise the loading lever even if the sub power is on.

      ER-642_Loading-lever-up

    • Lower the dancer roller toward the rear.

      LG_DancerRoller