Removing Media from the Take-up Unit

When output is complete, separate the media, take up the media manually, and then remove the media.

WARNING

Handling roll media is an operation that must be performed by 2 persons or more, and care must be taken to prevent falls.

Attempting to lift heavy media in a manner that taxes your strength may cause physical injury. Also, if dropped, such items may cause injury.

Procedure
  1. Lower the dancer roller toward the rear.

    VG3-640_PushDancerBar_WithMedia

  2. Close the front cover.
  3. With the media held down, separate it with "SHEET CUT".

    Separating the Media

    IMPORTANT
    Give Attention to the Media Composition
    • For some types of media, separation is not possible.
    • Some types of media may remain on the platen after separation. If the media remains on the platen, remove it by hand.
  4. Use the MANUAL switch to take-up the media.
    When using the FORWARD setting Take up the media with "FORWARD".

    Manual switch to wind outward
    When using the BACKWARD setting Take up the media with "BACKWARD".

    Winding inward with the manual switch
  5. While supporting the media from below, loosen the securing lever on the left media holder.

    VG3-640_LoosenLever_TU_withMedia

  6. With the media supported, pull the paper tube and media from the end cap.

    AP-640_RemovePaperTubefromTU