Ink Renewal Method (ER-641)

Perform the procedure below if ink discharge issues such as dot drop-out are not corrected after performing cleaning using the cleaning function (normal, medium, powerful) or manual cleaning.
IMPORTANT A large amount of ink will be discharged during this operation. Perform this operation only when ink discharge issues such as dot drop-out, dot displacement, and uneven colors cannot be corrected even after performing cleaning using the other cleaning functions (normal, medium, powerful, and manual).
CAUTION

Be sure to discard the discharged fluid at this stage.

A large amount of ink will be discharged during this operation. The discharged fluid must be discarded at this stage. If you do not discard it at this stage, discharged fluid may overflow from the drain bottle during the procedure that follows.

Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the following screen.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶] once, and then press [▼] several times to display the screen shown below.
    INK CONTROL_ER-641
  5. Press [ENTER].
    The screen shown below appears, and then ink renewal starts. The (approximate) remaining time for the procedure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and 45 seconds")

    MENU_RENEWING_INK

    When cleaning finishes, the screen shown below appears again.
    INK CONTROL_ER-641
  6. Press [MENU] to return to the original screen.