Expansion Ports

This machine is equipped with two expansion ports. When using a dust collector with built-in linking function, make sure you correctly understand the following specifications before connecting the dust collector's linking cable to the appropriate expansion port.

IMPORTANT

Before connecting or disconnecting the cable, be sure to turn off the machine's power. Connecting cables to or disconnecting cables from the milling machine while its power is on may cause malfunctions.

* We are not responsible for devices connected to this port.

IMPORTANT
  • Be sure to use the expansion port within the rated range.
  • Do not apply an additional voltage to the connector.
  • Do not short-circuit the connector to ground.
DWX-53D_ext_connectors

Expansion port A: Phone jack

Port type
Phone jack (3.5 mm [0.1 in.])*1
No. of pins
3
DWX-53D_ext_core_01
A 3.5 mm (0.1 in.)
B 14 mm (0.6 in.)
C 30 mm (1.18 in.) or less
OUTPUT 1+
OUTPUT 1-
N.C.

Expansion port B: Mini-DIN

Port type
Mini-DIN
No. of pins
8
extension_miniDIN
INPUT 2-
INPUT 2+
INPUT 1-
INPUT 1+
OUTPUT 2-
OUTPUT 2+
OUTPUT 1-
OUTPUT 1+

Internal circuit diagrams

The internal circuitry is the same for both expansion ports.

Input

extension_input
  • : INPUT 1+ or INPUT 2+
  • : INPUT 1- or INPUT 2-

Output

extension_output
  • : OUTPUT 1+ or OUTPUT 2+
  • : OUTPUT 1- or OUTPUT 2-