When Using a Tablet
When using a tablet to operate the machine, you can lean the tablet against the front of the machine. Pass the following two cables into the machine to use a tablet.
- A USB cable (included) to connect the machine and the tablet
- The tablet's charging cable
-
Attach the included cushions to the back of the tablet.
The tablet coming into contact with the built-in panel may lead to machine malfunctions. Attaching the cushions to the tablet provides a gap between it and the built-in panel.
-
Pull out the bottom storage.
-
Loosen the retaining screws on the bottom of the tablet base.
-
Pull out the tablet base from the bottom of the built-in panel.
-
Attach the tablet holders to the tablet base.
Adjust the tablet holders, and then tighten the screws.
-
Pass the cables to connect to the tablet through the cable insertion port at the back of the machine.
Pass the cables through the insertion port so the terminals to connect to the tablet reach the tablet base side.
MEMO To pass the cables smoothly, it is recommended to bundle the two cables such as by taping their tips together.
-
Pull out the inserted cables from the inside of the tablet base.
-
Connect the cables to the tablet, and then place it on the tablet holders.
IMPORTANT
Do not bend the USB cable.
Doing so may break the cable. The USB cable will bend if it is connected to the bottom of the tablet while it is held in the tablet holders. Use a commercially available L-shaped adapter to connect the included USB cable.
-
Match the tablet holders to the width of the tablet, and then tighten the screws to secure the tablet holders.
-
Push in the tablet base, and then tighten the retaining screws on the bottom of this base.
-
Connect the cable terminals at the back of the machine.
Connect the USB cable to connect the machine and the tablet to the USB connector at the back of the machine. Connect the tablet's charging cable to an electrical outlet.
