Dust Collector
Because this machine cuts and mills material, milling waste is generated during milling. You will need to prepare a dust collector separately.
To use a dust collector, insert its dust collection hose into the dust collection pipe of the machine.
IMPORTANT Milling cannot be performed without a dust collector.
WARNING
Be sure to turn on the dust collector.
Milling waste and workpieces are flammable and toxic.
WARNING
Never use a vacuum cleaner to clean up milling waste.
Picking up fine cuttings using an ordinary vacuum cleaner may result in fire or explosion.
The dust collector must meet the following conditions.
- Static pressure: 26 kPa or more
- 4 m3/min (141.26 ft.3/min) or more
- Dust collection hoses that meet the inner diameter or outer diameter of the dust collection pipe
A
- When covering the outer diameter of the dust collection pipe () with the dust collection hose ()
- Dust collection hose inner diameter: 50.8 mm (2 in.)
B- When inserting the dust collection hose () into the dust collection pipe ()
- Dust collection hose outer diameter: 45.6 mm (1.8 in.)
