Workpiece

Workpiece Materials

The materials that can be milled by this machine are as follows. To prevent machine malfunctions, be sure to check the material before milling.

  • Glass ceramics
  • Titanium alloys
  • Composite resins
  • PMMA
  • PEEK
  • Glass-fiber-reinforced resin
  • Baked zirconia

Types and Sizes of Workpieces

DWX-43W_size_pin
Type Type with pin
Size ø5.9 ± 0.02 mm (0.23 in. ± 0.79 mil)
Number of mountable workpieces Maximum 6*1
Size of mountable workpieces Width Maximum 40 mm (1.57 in.)
Height Maximum 20 mm (0.78 in.)
Depth Maximum 20 mm (0.78 in.)
*1 The number of mountable workpieces is limited by their sizes.

Workpiece sizes and the number of mountable workpieces

The following figures show the number of workpieces that can be mounted on the multi-pin clamp according to their sizes.

Width: less than 18 mm (0.7 in.), depth: less than 15.85 mm (0.62 in.) Width: 18 mm (0.71 in.) or more, depth: less than 15.85 mm (0.62 in.)*2 Depth: 15.85 mm (0.63 in.) or more*2
DWX-43W_worksize_01 DWX-43W_worksize_02 DWX-43W_worksize_03
*2 When performing cutting under these conditions, do not use the holder. Using the holder may lead to it coming into contact with and thereby damaging the spindle.
Pre-milled block*2
DWX-43W_worksize_04