Separating the Media

Separate the media after printing.

When removing the roll media after printing, use Sheet Cutting to separate the media.

Procedure
  1. Close the front cover.
  2. Tap Panel_Icon_SheetCut Sheet Cutting on the operation panel.
  3. Tap Feed + Sheet Cutting.
  4. Tap Execute.

    After the printed media is taken up by the take-up unit (with a feed amount of 600 mm [23.62 in.]), the media is separated from the roll.

    WARNING

    High Temperature

    Immediately after coming out of the oven, the separated media is very hot. Leave the media alone for at least 10 seconds, only touching it after it cools down.

  5. Press the manual switch on the take-up unit to take up the excess media.

    TU_rolled-up

  6. If necessary, remove the media from the take-up unit.