Operation Panel


DA-640_PN_panel

No.NameDetails
Status barDisplays the printer status and indicates the next operation.
HomeDisplays the home screen.
MenuDisplays various setting menus.
NotificationsDisplays important information. When there are notifications, their number is displayed next to the icon.
Sub powerControls the power to the operation panel.
Media information

Displays the media name, media width (W), and remaining media (L)*1. Tap the media width (W) or the remaining media (L) to display the Remaining Media Management screen on which you can set the remaining media.

Checking the Remaining Media
Amount of ink remainingDisplays the amount of ink remaining in each ink cartridge. If it is time to replace an ink cartridge, AP-640_Panel_Icon_CAUTION is displayed next to the corresponding cartridge. Tap this icon to display the detailed information for the ink.
Heater/oven temperatureThe print heater and oven temperatures are displayed as current temperature/set temperature. Tap one of these items to display a screen for:
  • Turning Print Heater on/off and setting its temperature.
  • Setting the temperature of Oven.
Amount of cleaning liquid remaining Displays the amount of cleaning liquid remaining. When the time for replacement arrives, AP-640_Panel_Icon_CAUTION is displayed.
Take-up unitDisplays the status of the take-up unit. Tap this icon to display the Take-up screen on which you can set the Take-up Mode and Take-up Method.
Setup/Cancel Setup

Starts/cancels the setting up of the media.

Setup of New MediaSetup of Registered Media
Cleaning/Nozzle Drop-out TestDisplays the menu related to the printing test and cleaning for the nozzle drop-out check.
Print light/Black Light/Off Switches the type of light that shines on the media close to the platen and turns the light off. To check the printing status of CMYK ink, select Print light. To check the printing status of structural ink, select Black Light.
Oven on/Oven off Operates the power supply of the heating unit (oven) for the foaming media.
MoveFeeds the media and moves the carriage. You can also set the position moved to as the right edge of the output area (the base point).

Adjusting the Output-start Location

Sheet CuttingActivates the separating knife to separate the media. To take-up media that is being heated and then separate it, select Feed + Sheet Cutting.
*1 This information is only displayed when media and the amount of remaining media have been set.