Replacing the Wiper

The wiper is a component that you use when cleaning the print heads.

When it is time to replace the wiper, the message The time for wiper replacement has arrived. appears. In this situation, replace the wiper.

For information about purchasing wipers, contact your authorized dealer or visit our website (https://www.rolanddg.com/).

WARNING

Be sure to perform operations as specified by the instructions, and never touch any area not specified in the instructions.

Sudden movement of the machine may cause injury.

Required item

Wiper_Assy


CleaningStick

DA-640_cleaning-liquid
Wiper Cleaning stick Cleaning liquid bottle for maintenance
MEMO If the inside of the printer is dirty, refer to Cleaning the Machine and perform cleaning.
Procedure
  1. When the message The time for wiper replacement has arrived. appears, tap OK.
  2. Remove any media.
  3. Tap Notification_Panel to display the messages.
  4. Tap The time for wiper replacement has arrived..
    The Wiper Replacement window appears.
  5. Tap Execute.

    The first step is displayed on the operation panel. Finish the work within 30 minutes to prevent the print heads from drying out. After 30 minutes, a warning message appears.

  6. Follow the instructions on the operation panel to replace the wiper.

    After finishing the instructed work, tap Panel_Icon_Right_Blue to display the next step. (There are some procedures where the next step is displayed automatically as you perform the work. In these situations, there is no need to tap the button.) In this manner, perform each step of the work in order. If you want to check the previous step or perform it again, tap Panel_Icon_Left_Blue.

    When you finish the last step, tap Finish All. Close the cover to finish the replacement. Dispose of the removed component.

  7. Tap Panel_Icon_Home.
    The home screen appears.