Automatically Making Required Adjustments

To optimize the output quality, corrections must match the media and printing conditions.

Misalignment of the ink landing position due to the printing conditions is automatically corrected to match the media.

First, print a test pattern. Then read this pattern with the multi sensor and automatically enter the correction values.

Executing automatic correction prints a test pattern, reads this pattern, and enters the correction values for the following operations.

  • Multi sensor adjustment (adjusting to the optimal condition the sensor used in correction)
  • Media gap adjustment (correcting the ink landing position)
Procedure
  1. Set up the media.
  2. Close the front cover.
  3. Tap Panel_Icon_Menu.
  4. Tap Media Settings - Printing settings - Batch Automatic Correction.
  5. Tap Execute.
    Test patterns are printed and correction values are entered for the following operations.
    • Multi Sensor Adjustment
    • Media Gap Adjustment
  6. Tap OK when the completion screen appears.
  7. Perform the operations shown below according to the Result.
    • If Successful is displayed on the operation panel, tap Panel_Icon_Home to go back to the home screen.
    • If Failed is displayed on the operation panel, carry out manual adjustment.