Stopping with the Wire

If you detect a hazard during work close to this machine, step on the wire to stop the operation of the printer unit.

Procedure
  1. Strongly step on the wire strung across the bottom of the main unit.
    Printer unit operation will immediately stop.
    EmergencySwitch_wire_ON
  2. After confirming that the situation is safe even if this machine starts operating again, operate the recovery device at the bottom of the transporter as shown in the figure to recover the operation of the printer unit.
    IMPORTANT Operation resumes immediately after it is recovered. Check the surrounding area and make sure it is safe before recovering operation.
    EmergencySwitch_wire_cancel
  3. Press [TS : RESET] to stop the warning beep.