Set the subnet mask.

Procedure
  1. Press [▼] to display the screen shown below.
    MENU_NETWORK_SUBNET
  2. Press [▶] twice to display the screen shown below.
    MENU_SUBNET_000000000000
  3. Press [▲] or [▼] to select the address number.
  4. Press [▶].
  5. Repeat steps 3 and 4 to set [SUBNET MASK] to "255.255.255.0."

    The numbers used in this section are examples.

    Note: For the subnet mask, make the setting the same value as the one used by the computer. Here, "255.255.255.0" is entered by way of example.
    MENU_SUBNET_255255255000
  6. When you finish making the setting, press [ENTER].
  7. Press [◀] to go back to the screen shown below.
    MENU_NETWORK_SUBNET

    If you are using the computer and the printer on a one-to-one basis, this completes the settings to make on the printer unit.

    Press [MENU] to go back to the original screen. Then, proceed to Setting the Software RIP.

    If you need to set the gateway address, proceed to the following procedure.