System Configuration of This Machine

"VersaWorks 6" is written as "VersaWorks," "BY Utility" is written as "Utility," and "FlexiDESIGNER VersaSTUDIO Edition" is written as "FlexiDESIGNER" in this manual.

System configuration

The following combination of devices and software can be used to generate output.

  • Output method A:

    FlexiDESIGNER

    You can generate output from FlexiDESIGNER. To do so, you have to install VersaWorks.

    BN2_SystemA
  • Output method B:

    Commercially available application software + VersaWorks

    To generate output, use commercially available application software to create data that can be processed by VersaWorks, and then send this data to VersaWorks. In VersaWorks, configure the settings required for output, and then generate output.

    BN2_SystemB
FlexiDESIGNER

Design and output software.

Use cutting lines and white ink to specify the locations to print.
VersaWorks

Software RIP (Raster Image Processor).
Utility

Software that is needed to operate the machine. The major functions are shown below.

  • Setting and adjustment functions
  • Management of ink remaining amount
  • Maintenance function
  • Display of messages and error messages
Commercially available application software

Designs patterns and creates cutting data. Use cutting lines and white ink to specify the locations to print.