Adjusting the Amount of Blade Extension

When you want to perform accurate and fine adjustment of the cutting-in amount, such as when cutting media with thin backing paper, you can obtain good results by adjusting the amount of blade extension (). Turn the cap portion of the blade holder to adjust the amount of blade extension. Each indicator tick corresponds to 0.1 millimeters, and adjustment for 0.5 millimeters can be made by rotating the cap one full turn.

Note that making the amount of blade extension too small may cause the tip of the blade holder cap to touch the printed surface, soiling and damaging it. It is important to be especially careful about this when you are using media that has poor ink-adhesion properties.

The amount of blade extension () is 0 mm (0 in.) () at minimum and 2.5 mm (0.09 in.) () at maximum.

Guideline for the Amount of Blade Extension

Set the amount of blade extension () to an amount that is the sum of the thickness of the media portion () and half () the thickness of the backing paper ().