Printing with Crop Marks Followed by Cutting

With this machine, you can print with crop marks, and then reload this media and cut it.

(Example: Perform lamination or other processing after printing, then reload the media and perform cutting.)

In this situation, carry out alignment to prevent misalignment of the printing results and the cutting lines. Refer to Performing cutting - Print laminate and cut in the VersaWorks Help and perform the following procedure.

Procedure
  1. Print with crop marks.
  2. Print with crop marks, remove the media, and then reload it.

    Points for Media Setting

    Place the crop marks () on the blade protector ().

    BN-20A_AligningAuto_C-C_place1

    Ensure that the angle is less than 5 degrees. Failing to do so will make alignment impossible.

    BN-20A_AligningAuto_C-C_place2
  3. Align to the printed crop marks and perform cutting.
    Starting Print Output