Insert the pin until the tip protrudes about 3 to 5 mm (0.12 to 0.19 in.).
Insert the blade into the blade holder.
Install the blade holder into the cutting carriage.
Open the front cover.
Loosen the cutting carriage screw.
Support the screw from below and insert the blade holder into the cutting carriage.
Failing to support the screw from below may compromise cutting quality.
Tighten the screw.
Check that the screw does not come loose even when it is pulled up.
IMPORTANTTighten the cutting carriage screw lightly when no blade holder is installed. Keeping the screw firmly tightened causes the blade holder insertion hole to become gradually smaller, making installation difficult.