Performing Various Adjustments Through a Sequence of Operations
You can perform various output adjustments through a sequence of operations by clicking Adjust All on the Adjustment tab. The adjustment method is the same as when adjusting settings individually.
When you click Adjust All, adjustment information is displayed.
- Next : Continues to the adjustment screen currently displayed on the screen.
- Skip : Skips the adjustment currently displayed on the screen.
- Cancel : Cancels the adjustment process.
The adjustments vary depending on the output method. Refer to the table below.
| Print (Only) | Cutting (Only) | Printing and Cutting | Crop Cut | |
|---|---|---|---|---|
| Check Nozzle Condition | ○ | - | ○ | ○ |
| Bidirectonal adjustment*1 | ○ | - | ○ | ○ |
| Calibrate Sheet Feed Amount | ○ | ○ | ○ | ○ |
| Cut Adjustment | - | ○ | ○ | ○ |
| Print Cut Adjustment | - | - | ○ | ○ |
| CropCut Adjusutment | - | - | - | ○ |
*1 This is available when bidirectional printing is set in the BN-20 driver or VersaWorks.