Aligning Automatically and Cutting

This section describes how to make settings when using the BN-20 driver. When using VersaWorks, refer to the VersaWorks Help.
Procedure
  1. Print with a crop mark, and then reload the media that was removed.

    Points for Media Setting

    Place the crop marks () on the blade protector ().

    BN-20A_AligningAuto_C-C_place1

    Angled no more than 5 degrees. Otherwise alignment becomes impossible.

    BN-20A_AligningAuto_C-C_place2
  2. Display the BN-20 driver's Printing Preferences screen.How to Open the BN-20 Driver's Printing Preferences Screen
  3. Select CropMark on the Printer Adjustment tab.
    BN-20A_DriverCrop
  4. Select Cut.
    BN-20A_DriverCrop_02
    IMPORTANT: Before you start cutting, check that media size in the Settings tab of Printing Preferences Screen is the same as the size used for printing. When you perform cutting, set the same media size as the printing. If not, misalignment between the printing results and the cut lines might occur.
  5. Start cutting.
    Step 5: Starting Print Output