Printing with Crop Marks

This section explains how to specify settings when using the BN-20 driver. When using VersaWorks, refer to theVersaWorks Help.
Procedure
  1. Display the BN-20 driver's Printing Preferences dialog box.Displaying the BN-20 Driver's Printing Preferences Dialog Box
  2. On the Printer Adjustment tab, select the CropMark check box.
    BN-20A_DriverCrop
  3. Select Print.
    When Printing & Cut is selected, the media is pulled back after printing with crop marks is performed, and then cutting starts immediately. The printer detects the crop marks to perform cutting.
    BN-20A_DriverCrop_01
    IMPORTANT Before you start printing, check the media size on the Settings tab on the Printing Preferences dialog box and write it down. If the media size during cutting is not set to the same size as that used during printing, the cutting lines may be misaligned compared to printing.
  4. Click OK.
  5. Start printing.
    Step 5: Starting Print Output

    The crop marks are printed as shown in the figure.

    BN-20A_PrintWithCrop2
    • : Align points
    • (B): Base point
    IMPORTANT Alignment marks and symbols drawn using graphics software cannot be used as crop marks.