3. Check and correct the printing test results.

Procedure
  1. Check the test pattern.
    Calib_LR

    The value below the location where there is the least deviation between the overlapping lines is the correction value. The value where there is the least deviation for Ch0 is -2. Check the value below the location where there is the least deviation for Ch0 through Ch7.

  2. Enter the correction values that were checked in step 1 into ch0 to ch7 for Calibrate to the left.
    Calib_L_Inp

    Click Save.

  3. Attach the object to be printed on for the printing test.
    1. Attach the object to be printed on for the printing test.
  4. Perform the printing test again.
    2. Perform a printing test.
  5. Check the test pattern.

    Adjustment is completed if the least amount of deviation is at the 0 position.

    If it is deviated, check the correction value and repeat adjustment until the least amount of deviation is at the 0 position.

  6. Click × to close the window.