1. Attach the object to be printed on for the printing test.

IMPORTANT
Open and close the front cover and right cover gently. If you open and close them forcefully or release the cover when it is partly open, not only may it malfunction, but you may also be injured. When opening and closing the front cover, grasp the center of the front cover to open or close it.
CoverCaution
Procedure
  1. Open the front cover.
  2. Press the [FRONT] button and move the flat table forward to a position where the object to be printed on for the printing test can be installed.
    MEMO

    The flat table will continue moving if you press and hold the [FRONT] button for three seconds or longer and then release it. To stop the movement, press [FRONT] again or press the [BACK] button.

  3. Press the [UP] or [DOWN] button to adjust the flat table height.
    Press the [UP] or [DOWN] button and change the value of "Height" on the display screen to the thickness of the object to be printed on for the printing test.
    ThicknessMedia
  4. Install the object to be printed on for the printing test onto the flat table.
    Install so that it is aligned with the bottom right corner of the flat table.
  5. Press the [SUC] button.
    The suction fan activates to suction the object to be printed on in place.
    MEMO

    If the ends of the object to be printed on are rolled up, if the object to be printed on is thick, and in similar situations, it may not be possible to secure the media in place. For objects to be printed on whose ends are rolled up, secure the ends of the object to be printed on with tape so that dimension a is 5 mm (0.20 in.) or less, and then use the suction function. If the tape application margin exceeds 5 mm (0.20 in.), the test pattern may be printed on the tape.

    Object_TestPrint
  6. Move the flat table to the printing test start position.
    Press the [BACK] button and move the flat table to the printing test start position. The nozzle surface of the print heads is located at a position 30 mm (1.18 in.) inward from the front of the UV-LED device. Position the front edge of the flat table at position A 25 mm (0.98 in.) inward from the front of the UV-LED device.
    MEMO

    The flat table will continue moving if you press and hold the [BACK] button for three seconds or longer and then release it. To stop the movement, press [BACK] again or press the [FRONT] button.

    HeightADJ2
  7. Close the front cover.