Step 3: Perform Printing

MEMO Depending on the computer display settings, the Send to Device or Print parameters window may not fit on the monitor. If this occurs, adjust the magnification and layout in the display settings.
Procedure
  1. Open the printing data created in FlexiDESIGNER.
    Click File - Open to open the saved printing data.
  2. Click BD-8_Flexi-Icon_SendtoDevice.
    The Send to Device dialog box opens.
  3. Check the following.
    • Device: BD-8
    • Number of prints: 1
    • Output:Page
  4. Click Print parameters.
  5. In the Quality tab, select the following.
    • Media Type:General
    • Print Quality:High Quality
    • Mode: White->CMYK (v)
    • Special Color Plate Generation
      • White Plate Generation: Select the check box.
      • Generated Pattern:Print Area
      • Size Correction:No
  6. Click OK.
    The Print Parameters window closes.
  7. Click Send.
    Printing starts.
  8. Once printing is complete, remove the object, and exit out of setup in Utility.