Flat Table Height Setting
In the following cases, settings related to the flat table height need to be configured.
- Printing in layers (i.e., the printing surface gradually becomes higher).
- The height of the object changes during printing due to lifting up or warping of the printed object.
- Mass-producing an object whose height varies due to differences among individual objects without changing the height of the registered media.
There are two height settings for the flat table.
- Readjust
The height of the flat table is readjusted when the head gap sensor comes into contact with the object during printing.Readjusting Height during Printing
- Flat Table Lowering Amount
Printing is performed by lowering the flat table in advance below the specified value.Setting a Longer Distance between the Object and the Print Heads
- Flat Table Height/Object (Media) Thickness
Select whether the base position (0 mm [0 in.]) in the flat table height direction should be set to "Lowest position: Height (H)" or "Highest position: Thickness (T)."Setting the Reference Position of the Flat Table in the Vertical Direction