Media Separation Location during Continuous Printing

When a command for separating the media is sent from the computer, the separation location on the media is as shown in the figure below.


First page
Second page
Separation location
When Pullback After Printing is
  • Disable: 370 mm (14.57 in.)*1
  • Enable: Software RIP value (default setting: 80 mm (3.15 in.)
A When the Sheet Cutting method after the printing of the first page is

Sheet Cutting: 370 mm (14.6 in.)

Perforated Sheet Cutting: 70 mm (2.76 in.)

*1 In order to allow the printing area to dry, media must be fed to the dryer up to the trailing edge of the printing area. When preparing media, leave at least 400 mm (15.75 in.) of margin from the printing area.