Changing the Media Settings

Use the following procedure to change the media settings. These settings can only be changed for the media being set up.
Procedure
  1. Load the media.
  2. Tap AP-640_Panel_Icon_MENU.
  3. Tap Media Settings - List of Media Settings.
  4. Tap the setting to change to move to the screen for editing this setting.
    The media settings that can be changed are as follows.
    Menu item Reference page
    Print Head Height Changing the Print Head Height
    Feed Correction Manual Adjustment: Reducing Horizontal Bands (Feed Correction)
    Media Gap Adjustment Manual Adjustment: Adjusting the Misalignment of the Ink Landing Position (Media Gap Adjustment)
    Heater Temperature Setting the Print Heater TemperatureSetting the Dryer Temperature
    Pullback After Printing Using Heat-resistant Media with Minimal Waste
    Multi Sensor Adjustment Adjusts the sensor used to make corrections to the optimal condition.
    Media Suction Force Using Media That Wrinkles Easily/Does Not Move Smoothly
    Printing Movement Range Speeding Up Output for Narrow Media
    Media Sticking Prevention Using Sticky Media
  5. If you have changed a setting, tap Save.
  6. Tap AP-640_Panel_Icon_HOME to go back to the original screen.