The media could not be detected automatically. Manually set the printing area.

This message appears when media with high reflectance is set up. Manually set the printing area.

The Sheet Settings screen appears. Configure the settings as shown below depending on the sheet type.

  • Sheet Width setting
    1. Tap Sheet Width.
    2. Enter the sheet width and tap OK.
  • Sheet Right Edge setting
    1. Tap Change next to Sheet Right Edge.
    2. Tap AP-640_Panel_Icon_LEFT or AP-640_Panel_Icon_RIGHT to move the sub carriage's base point mark to the right edge of the media.
    3. Tap OK.
  • Side Margin setting
    1. Tap Side Margin to set the margin.

      You can select 5 mm (0.2 in.), 10 mm (0.39 in.), or 25 mm (0.98 in.).

    2. Tap OK.