Emergency Measure) Cleaning the Print Head Surface

When dot drop-out or dot deflection is not improved even if cleaning is performed several times, you can clean the surface of the print heads as an emergency measure. The print head surface (nozzle surface) is a very delicate mechanism, so work must be performed carefully and cautiously.

This operation is an emergency measure. It may damage defect-free parts depending on the symptoms, worsening the symptoms. If you have any questions, contact your authorized dealer.

WARNING

Be sure to perform operations as specified by the instructions, and never touch any area not specified in the instructions.

Sudden movement of the machine may cause injury.

IMPORTANT

Important notes on this procedure

  • Before attempting this operation, remove any media.
  • To prevent the print heads from drying out, finish this procedure in 30 minutes or less. A warning beep sounds after 30 minutes.
  • Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may damage the print heads.
  • Do not use a dropper or cleaning liquid other than those included.
  • Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks will adversely affect the printing results.
  • Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the cleaning liquid.
  • Never rub the print head surface (nozzle surface).
  • Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.
  • If you use up the cleaning sticks or cleaning liquid, contact your authorized dealer or visit our website (https://www.rolanddg.com/).

When an alarm sounds during cleaning

  • A warning beep sounds 30 minutes after operation starts. Stop work, close all the covers, and then press Finish All to end the manual cleaning mode. After that, restart the procedure from the beginning.
Required items




Cleaning stick Cleaning liquid
Procedure
  1. Remove any media.
  2. Tap AP-640_Panel_Icon_MENU.
  3. Tap Cleaning - Manual Cleaning.
  4. Tap Execute.
    MEMO The procedure is displayed on the operation panel.
    • Tap VG3_Panel_Icon_LEFT_blue or VG3_Panel_Icon_RIGHT_blue to check the procedure.
    • If you complete the work without viewing the instructions, tap Finish All.

    The print heads move to the left end of the machine.

  5. Open the right cover.

    XP_RvoverOpen
  6. Open the left cover.

    ER-642_CoverL-open
  7. Moisten a new cleaning stick with the cleaning liquid.
    IMPORTANT
    • Be sure to use one of the included cleaning sticks.
    • Do not use a previously used cleaning stick.
    • Do not put a previously used cleaning stick into the cleaning liquid.


  8. Very gently touch the cleaning stick against the print head surface (nozzle surface).

    Very softly press the cleaning stick against the print head so that cleaning liquid soaks into the print head surface (nozzle surface). Never rub the stick on the surface or press it forcibly.

    IMPORTANT Mainly push the cleaning stick into the grooves on the head surface ().

    Cleaning the print head_groove
  9. Close the left and right covers.
  10. Tap Finish All.

    Normal cleaning in progress. is displayed at the top of the screen, and cleaning starts.

  11. Tap AP-640_Panel_Icon_HOME to go back to the original screen.