Step 4: Reinstalling the Machine

Procedure
  1. Once the preparations are complete, move the machine with as little delay as possible.
  2. Immediately reinstall the machine, and then open the front cover.

    open front cover
  3. Remove retainer C, which secures the sub carriage in place.
    Fixing fixture C
  4. Open the left cover.

    ER-642_CoverL-open
  5. Install retainer C at the position indicated in the figure for storage.
    Tighten fixture C
  6. Close the front and left covers.
  7. Turn on the main power switch.
    IMPORTANT

    To prevent the print heads from being damaged, move the machine with as little delay as possible and switch on the main power as soon as possible after moving the machine. To install the machine again, follow the procedure in the Setup Guide.

  8. Press the sub power button.
    The home screen appears.
    MEMO If the initial setup or the ink filling is not complete, the language selection screen will appear. Follow the instructions on the screen to carry out the initial setup and ink filling.