Operation Panel


ER-642_Panel

No. Name Details
Status bar Displays the printer status and indicates the next operation.
Home Displays the home screen.
Menu Displays various setting menus.
Notifications Displays important information. When there are notifications, their number is displayed next to the icon.
Sub power Switches the sub power of the machine on/off.
Media information Displays the media name and media width (W) for media that has been set up. If the remaining media setting has been configured, the remaining media (L) is also displayed. Tap the media width (W) or the remaining media (L) to display the Remaining Media Management screen on which you can set the remaining media.

Checking the Remaining Media
Amount of ink remaining Displays the amount of ink remaining in each ink cartridge. If it is time to replace an ink cartridge, icon_Panel_Error_Caution is displayed next to the corresponding cartridge. Tap this icon to display the detailed information for the ink.
Heater Temperature The print heater and dryer temperatures are displayed as current temperature/set temperature. Tap one of these items to display a screen for:
  • When media is set up
    • Turning Heater Power on/off.
    • Turning Print Heater on/off and setting its temperature.
    • Turning Dryer on/off and setting its temperature.
  • When no media is set up
    • Turning Standby Heater Temperature on/off and setting its temperature.
Take-up Unit Displays the status of the take-up unit. Tap this icon to display the Take-up screen on which you can set the Take-up Method and Take-up Direction.
Amount of cleaning liquid remaining Displays the amount of cleaning liquid remaining. When the time for replacement arrives, icon_Panel_Error_Caution is displayed.
Setup/Cancel Setup

Starts/cancels the setting up of the media.

Setup of New Media

Setup of Registered Media
Cleaning/Nozzle Drop-out Test Displays the menu related to the printing test and cleaning for the nozzle drop-out check.
Blade Adjustment Sets cutting conditions. This is only enabled when media has been set up.
Move

The media can be fed and the cutting carriage can be moved. You can also set the position moved to as the right edge of the printing area (the base point).

Adjusting the Output-start Location
Sheet Cutting Activates the separating knife to separate the media. You can also perforate the media to take it up and separate it at a later time. This is only enabled when media has been set up.