2. Register the media.

Procedure
  1. Tap Panel_Icon_Setup Setup.
  2. Select New.
  3. Tap Next.
    NewMedia_Panel
  4. Enter a new media name and tap OK.

    Tap the keyboard displayed on the screen to enter the name.

    You can use up to 15 alphanumeric characters.

    Medianame_Panel
  5. Check the name you have entered and tap Next if it is correct.
    To make corrections, tap the name you entered.
  6. The Setup Method screen appears. Select whether to use the take-up unit.
  7. Tap Start Setup.
    The cutting carriage moves and detects the width of the media and the positions of the media clamps. This operation is called initialization.
  8. When The media could not be detected automatically.Manually set the printing screen appears, use the following procedure to configure the settings.
    MEMO This message may appear when media with high reflectance is set up.
    1. Tap OK.
    2. Tap Change.
      The Set the right edge of the printing area within the area specified by the window appears.
    3. Hold down Panel_Icon_LeftArrow or Panel_Icon_RightArrow to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the left edge of the right pinch roller.

      VG3_MediaWidthSetting_manual_R
    4. Tap OK.
      The Set the left edge of the printing area within the area specified by the window appears.
    5. Hold down Panel_Icon_LeftArrow or Panel_Icon_RightArrow to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the right edge of the left pinch roller.

      VG3_MediaWidthSetting_manual_L
    6. Tap OK.
      The set left and right positions are applied to the Printing Area (Width).
    7. Tap OK.