Adding Jobs That Perform Only UV Lamp Irradiation after Printing
This section explains how to duplicate a job to add a job that performs only UV lamp irradiation. This procedure is useful in situations such as when you want to retain a job to print as a separate job. Adding a job where only UV lamp irradiation is performed after printing will efficiently allow additional UV irradiation.
Depending on the model you are using, this setting may be disabled.
Procedure
- Use one of the methods below to create a UV Post Cure Job.
- Right-click the job to duplicate, and then click .
- With the job to duplicate selected, click
on the left side of the job tool area, and then click 
UV Post Cure Job.
The job is duplicated, and the duplicate job performs only UV irradiation. The
icon is added to the job name field.If there are multiple jobs in the job list, the duplicate job is added at the bottom of the list.
MEMO If you want to perform only UV irradiation after printing, group the jobs before outputting them.Outputting Multiple Jobs at Once - If necessary, change the job name.