Reducing the UV Lamp Illumination Intensity

Depending on the media, the standard illumination intensity may be too strong, affecting the printing quality. Additionally, there are printing methods where it is desirable to not cure the ink, allowing for decoration. This section explains how to configure the settings to reduce the illumination intensity of the UV lamp in these situations.

If you change Media Name, Print Quality, Resolution, or Mode after configuring settings, set the illumination intensity again.

Depending on the model you are using, this setting may be disabled.

Procedure
  1. Perform the operation shown below according to what is being set.
    • Job
      • Double-click the job to set.
      • Right-click the job to set, and then click Edit Design - Settings.
      • With a job selected, click VW7_JobMenu1 on the left side of the job tool area, and then click VW7_Customize Settings.

      The Settings window appears.

    • Queue folder: Click VW7_Customize for the queue folder.

      The Queue Properties appears.

  2. Click VW7_PrinterControl Printer Controls.
  3. Select the Change UV Lamp Irradiation Intensity checkbox under UV Lamp Control.
  4. When a window warning you about changing the illumination intensity appears, click OK.
  5. Set the Irradiation Intensity.
  6. Click OK.
    • Any changes made in Settings will be applied, and you will be returned to the main window.
    • When changes are made in Queue Properties:
      • When a message for saving the printing settings appears, click OK.

      • To apply the changes to a job already in the queue folder, right-click the job and click Copy/Paste Setting Value - Apply Current Queue Settings.