Increasing Memory

With a large quantity of image data, a memory shortage may occur, which may result in processing by the RIP and output becoming slow or impossible, or prevent print data from being added to the job list. In this case, increase the amount of memory.
Procedure
  1. Click Edit - Preferences on the menu bar.
    The Preferences window appears.
  2. Click the General tab.
  3. Adjust Memory Amount under Adjust Amount of Memory Used in RIP.
    Drag the slider or click its left and right sides to change the amount of memory.

    The default value is 1024 MB.

  4. Click OK to close the Preferences window.