9. Machine settings

Use this window to set the machine and perform maintenance operations.

General Tab

Configure the settings for the machine selected in the top window.


VPanel_for_DWX_Setting_Setting_DWX-52DCi


Machine ID setting
When multiple machines are connected to one computer, it's necessary to set IDs for the machines. Select the machine to use in the VPanel top window.

For detailed operation, refer to the Setup Guide of the model you are using.

DWX-42W Setup Guide
Initial setting:A
IMPORTANT To change an ID, be sure to follow the procedure explained in the Setup Guide.
Cleaning adapter mode
You can change the setting for blowing compressed air into the adapter to remove milling waste after milling finishes.
Selecting High quality makes it easier to remove milling waste but lengthens the milling time. Selecting High speed shortens the milling time but makes it easy for milling waste to remain in the adapter.
Initial setting: Standard
Machine Information

Serial: Serial number of the machine

Driver: DGSHAPE dental driver version

Firmware Main: Connected machine's main firmware version

Firmware Changer: Connected machine's disc changer firmware version

MEMO When you are signed in to DGSHAPE CLOUD with a DGSHAPE account, you can set the nickname of the machine. Nicknames can be used as identifiers for each machine when you are using multiple machines.

Maintenance Tab

On this tab, you can perform operations related to maintenance, including automatic correction of the milling machine and system reporting. When more than one machine is connected, the machine selected in the top window becomes the target for the operations. For detailed operations, refer to the User's Manual of the model you are using.

DWX-42W User's Manual

VPanel_for_DWX_Setting_Maintenance

Correction
Automatic correction
Correct the ATC magazine position or the rotary axis position.
Support
Move to packing position
Moves the rotary axis unit, ATC magazine, and spindle unit to the packing position. Remove the workpiece and the correction jig before performing this work.
Drain coolant
Drains the coolant inside the coolant tank. Use this function when you will not use the machine for an extended period and before you move the machine.
7. Milling area cleaning
Check coolant flow
Checks whether the coolant flow rate is normal. Use this function at the end of the day's work to keep the machine in good working order.
ATC
Milling bur change test
Perform tests, maintenance, and other tasks related to operation with the ATC magazine.
Report/Log
Show
Displays the error window as well as system information such as the firmware version and the total operating hours.
Get
Obtain a file in which the information of the various logs is collected.
Spindle
Spindle run-in
Performs spindle run-in (warm-up), which stabilizes the rotation of the spindle.
Emergency tool release
This button is enabled when the machine is turned on while a cover is open. Use this button if the initial operations cannot be performed because, for example, the milling bur is caught on the workpiece.
Coolant tank
Filter replacement time
Allows you to set the filter replacement time. Click Settings, enter the replacement time, and then click OK.
Coolant replacement time
Allows you to set the coolant replacement time. Click Settings, enter the replacement time, and then click OK.