8. Machine settings

Use this window to set the machine and perform maintenance operations.

General Tab

Configure the settings for the machine selected in the top window.

VPanel_for_DWX_Setting_Setting_DWX-52DCi

Machine ID setting: When multiple machines are connected to one computer, it's necessary to set IDs for the machines. Select the machine to use in the VPanel top window.
For detailed operation, refer to the Setup Guide of the model you are using.
DWX-52D Setup Guide DWX-52Di Setup Guide; Initial setting:A; IMPORTANT To change an ID, be sure to follow the procedure explained in the Setup Guide.

Cleaning adapter mode: You can change the setting for blowing compressed air into the adapter to remove milling waste after milling finishes.; Selecting High quality makes it easier to remove milling waste but lengthens the milling time. Selecting High speed shortens the milling time but makes it easy for milling waste to remain in the adapter.; Initial setting: Standard

Machine Information

Serial: Serial number of the machine

Driver: DGSHAPE dental driver version

Firmware Main: Connected machine's main firmware version

Firmware Changer: Connected machine's disc changer firmware version

MEMO When you are signed in to DGSHAPE CLOUD with a DGSHAPE account, you can set the nickname of the machine. Nicknames can be used as identifiers for each machine when you are using multiple machines.

Maintenance Tab

On this tab, you can perform operations related to maintenance, including automatic correction of the milling machine and system reporting. When more than one machine is connected, the machine selected in the top window becomes the target for the operations. For detailed operations, refer to the User's Manual of the model you are using.

DWX-52D User's Manual DWX-52Di User's Manual

Correction

Automatic correction / Manual correction: Correct the ATC magazine position or the rotary axis position. Normally use Automatic correction. Perform Manual correction to increase the milling accuracy. Performing Manual Correction; If a message prompting you to carry out Temperature change correction appears in VPanel, carry out Temperature change correction.

Support

Move to packing position: Moves the rotary axis unit, ATC magazine, and spindle unit to the packing position. Remove the workpiece and the correction jig before performing this work.
Milling area cleaning: Use this button when you clean the machine.; 6. Milling area cleaning
Disc changer run-in: Performs disc changer run-in (warm-up), which stabilizes the disc changer operation and maintains the milling quality.

Report/Log

Show: Displays the error window as well as system information such as the firmware version and the total operating hours.
Get: Obtain a file in which the information of the various logs is collected.

Spindle

Reset: Work time displays the work time of the spindle. After replacing the spindle unit, click Reset to reset the value to 0. For spindle unit replacement time guidelines, refer to the User's Manual of the model you are using.
Spindle run-in: Performs spindle run-in (warm-up), which stabilizes the rotation of the spindle.
Spindle replacement: Opens the Spindle replacement window.
Collet maintenance: Continuous milling will cause the collet to become loose, making it easy for the milling bur to come off. Use these buttons when retightening the collet and in other periodic maintenance. Follow the on-screen instructions to perform the maintenance work.
Forced tool release: Forces the spindle unit to release the tool it is gripping. Use this button when the spindle unit cannot release the tool it is gripping.
Emergency tool release: This button is enabled when the machine is turned on while a cover is open. Use this button if the initial operations cannot be performed because, for example, the milling bur is caught on the workpiece.