Step 2: Starting Output

CAUTION:

Never touch the print-head carriage while output is in progress.

The print-head carriage moves at high speed. Coming into contact with the moving carriage may cause injury.

  1. Close the front cover.
  2. Check that SETUP is lit.
    If SETUP is not lit, the setup is not completed. Lower the loading lever, and then press the ENTER key.
  3. Check that the screen shown below (the top menu) is displayed.
    If the top menu is not displayed, press MENU.


  4. Send the output data from the computer.
    For information on how to create the output data, refer to the documentation for the included software RIP.

    IMPORTANT:

    Output Is Not Possible in These Situations

    • The machine does not run when a cover (front, left, right, or ink slot) is open.

    • Data from the computer is not accepted when SETUP is dark.

    • Data from the computer is not accepted when you are not at the top menu.

    Points that must be observed

    • Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.

    • During output, do not touch the media. Doing so may obstruct the media feed or cause the media to rub against the print heads, which may result in a paper jam or damage to the heads.

    • Keep the loading lever raised when the machine is not in use.

    When not using the machine, remove any media and store it in a suitable environment.

    • If the machine is left with the media loaded, the media may be damaged, which may adversely affect printing. When not using the machine, remove any media and store it in a suitable environment.