1 Clean the print head caps.

  1. Remove any media.
  2. Press FUNCTION.
  3. Press ▶ once, and then press ▼ several times to display the screen shown below.


  4. Press ENTER.
    After "NOW PROCESSING.." is displayed, the screen shown below appears.
    Also, the print head moves to the left end of the platen.


    IMPORTANT:

    Do not press ENTER at this stage. Press the ENTER key after cleaning is complete. If you press the ENTER key at this stage, wait for the screen to change as shown in the following figure, and then press the ENTER key again.





  5. Open the right cover.


  6. Touch the location shown in the figure to discharge any static electricity.


  7. Moisten the cleaning stick with the cleaning liquid.
    IMPORTANT:

    Be sure to use one of the included cleaning sticks.



  8. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).


  9. When you have finished cleaning, close the right cover.