Setting the Drying Time after Printing (When Printing and Cutting)

To dry the ink thoroughly, set the drying time after the 1st page is printed. This setting applies to output data designed for printing and cutting.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the screen shown below.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶], then [▼] to display the screen shown below.


  5. Press [▶] to display the screen shown below.


  6. Press [▲] or [▼] to select the drying time.
  7. Press [ENTER] to confirm your entry.
  8. Press [MENU] to go back to the original screen.
    MEMO:

    • Default setting: 0 min

    • The next operation is not started until the set time elapses.

    • During drying, [PAUSE] is lit. Press [PAUSE] while [PAUSE] is lit to finish the drying time and start the next operation.

    • Hold down [PAUSE] while [PAUSE] is lit to cancel the output.

    • When you have configured this setting, we recommend setting the "FEED FOR DRY P&C" menu to "ENABLE". (Drying the Trailing Edge of the Printing Area on the Dryer (When Printing and Cutting))

    • This setting is also applied during printing and cutting with crop marks.

    • When the drying time has been set in the software RIP, priority is given to the software RIP's setting.

    • This setting is ignored for output data designed only for printing. To set the drying time after printing when only printing, see the following section.