1. Clean the print head caps.

Procedure
  1. Remove any media.
  2. Press [FUNCTION].
  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [ENTER].
    After "NOW PROCESSING" is displayed, the screen shown below appears.
    Also, the print head moves to the left end of the platen.


    IMPORTANT:

    Do not press [ENTER] at this stage. Press the [ENTER] key after cleaning is complete. If you press the [ENTER] key at this stage, wait for the screen to change as shown in the following figure, and then press the [ENTER] key again.





  5. Open the right cover.


  6. Touch the location shown in the figure to discharge any static electricity.


  7. Moisten the cleaning stick with the cleaning liquid.
    IMPORTANT:

    Be sure to use one of the included cleaning sticks.



  8. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).


  9. When you have finished cleaning, close the right cover.