Using Hard-to-Dry Media
Procedure
- Press [MENU].
-
Press [▼] several times to display the screen shown below.
-
Press [▶], then [▼] to display the screen shown below.
-
Press [▶] to display the screen shown below.
-
Press [▲] or [▼] to select a value.
Larger values cause the media to move more slowly, enabling you to extend the drying time accordingly.
- Press [ENTER] to confirm your entry.
-
Press [MENU] to go back to the original screen.
MEMO:
Default setting: "OFF"
Depending on the software RIP you are using, you can also make this setting in the software RIP. When you have made the setting in the software RIP, the printer's setting is ignored.