5. Adjust the misalignment of the ink landing position.

Procedure
  1. Press [◀] to select "SET".


  2. Press [ENTER] to confirm your entry.
    Printing of the test pattern starts.

    You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.

  3. Press [ENTER].


  4. View the printed test pattern, and then determine the correction value.
    Select the value that gives the least misalignment between the two lines. In the case of the following figure, select "-3." When you cannot choose between two sequential numbers, select a value that is between them (you can set correction values in units of "0.5").


  5. Press [▲] or [▼] to select the correction value.


  6. Press [ENTER] to confirm your entry.
  7. Press [◀] to select "SET".


  8. Press [ENTER] to confirm your entry.
    The test pattern is printed again. Check that the misalignment is minimized for the two vertical lines indicated by "" (that is, the current correction value). If the difference between the two vertical lines is smaller in other locations, return to step 5 to configure the setting again.

    If you do not need to change the correction value, press [ENTER] again.

  9. Press [▶] to select "DONE".


  10. Press [ENTER] to confirm your entry.