2. Clean the print heads.

Procedure
  1. Open the front cover.
  2. Open the left cover.


  3. Remove the cut rail.


  4. Move the print-head carriage to the position where the cut rail was present.


    Move it by holding the positions indicated with () in the following figure.

    CAUTION:

    When moving the print-head carriage by hand, be sure to hold the specified position.

    Moving it by holding positions other than those specified may deform and damage the cover.



  5. Moisten the cleaning stick with the cleaning liquid.
    IMPORTANT: Be sure to use one of the included cleaning sticks.


  6. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).


  7. When you have finished cleaning, move the print-head carriage to above the platen.


    Move it by holding the positions indicated with () in the following figure.

    CAUTION:

    When moving the print-head carriage by hand, be sure to hold the specified position.

    Moving it by holding positions other than those specified may deform and damage the cover.



  8. Attach the cut rail.


  9. Close the left cover.
  10. Close the front cover.
  11. Press [ENTER].


    The screen shown below appears, and then cleaning starts. The (approximate) remaining time for the procedure is displayed on the screen. (The display shown below is an example. "01:45" = "1 minute and 45 seconds")


    When cleaning finishes, the screen shown below appears again.


  12. Press [FUNCTION] to go back to the original screen.