Setting the Drying Time after Printing

To dry the ink thoroughly, set the drying time after the 1st page is printed.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the screen shown below.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶] to display the screen shown below.


  5. Press [▲] or [▼] to select the drying time.
  6. Press [ENTER] to confirm your entry.
  7. Press [MENU] to go back to the original screen.
    MEMO:

    • Default setting: 0 min

    • The next operation is not started until the set time elapses.

    • During drying, [PAUSE] is lit. Press [PAUSE] while [PAUSE] is lit to finish the drying time and start the next operation.

    • Hold down [PAUSE] while [PAUSE] is lit to cancel the output.

    • When the drying time has been set in the software RIP, priority is given to the software RIP's setting.