Step 3: Check the adjustment results.

Procedure
  1. Tap Execute next to Output Start Location.
  2. Tap AP-640_Panel_Icon_UP, AP-640_Panel_Icon_DOWN, AP-640_Panel_Icon_LEFT or AP-640_Panel_Icon_RIGHT to move the center of the blade to the position that you want to set as the base point.
    Tap AP-640_Panel_Icon_UP or AP-640_Panel_Icon_DOWN to move the media. Tap AP-640_Panel_Icon_LEFT or AP-640_Panel_Icon_RIGHT to move the cutting carriage.

    CutTestPrint5

    • : Base point (right edge of the output area)
  3. Once the position has been decided, tap [Set Base Point Here] to confirm it.
  4. Close the front cover.
  5. Tap Execute next to Cutting Test.

    The test pattern is cut.

    CutTestPrint3
  6. Open the front cover.
  7. Check the results of the cutting test again.
  8. When the correction is finished, tap AP-640_Panel_Icon_HOME to go back to the original screen.