Correcting the Misalignment of the Printing and Cutting Positions during Cutting

This method pauses a cutting operation to correct the misalignment of the printing and cutting positions. The correction values set here are applied as the default values of the printing and cutting positions.

If the printing and cutting positions are misaligned, you normally adjust the positions while checking a test pattern.

Procedure
  1. During cutting, press [PAUSE] to display the screen shown below.


    The cutting operation is paused.
  2. Press [FUNCTION].
    The screen shown below appears.
  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶].
  5. Determine the correction values.
    MEMO

    Determine the values so as to correct the misalignment of the cutting position () in relation to the printing position (). In the case of the following figure, feed direction "F" is misaligned in a negative direction and scan direction "S" in a positive direction. Therefore, set the correction values for the feed direction "F" to positive values and the scan direction "S" to negative values. Measure the actual misalignment amount when determining the value.



  6. Set the correction values for the feed direction "F" and scan direction "S".
    1. Press [▲] or [▼] to set the correction value for the feed direction "F".


    2. Press [◀] or [▶] to set the correction value for the scan direction "S".


    3. When you have finished setting the correction values, press [ENTER].
  7. Press [PAUSE] to display the following screen.


  8. Press [PAUSE] again to restart the cutting operation.
    Hold down [PAUSE] for 1 second or longer to cancel the cutting operation.
    MEMO

    Default settings

    • "F" (correction value of the media feed direction): 0.00 mm
    • "S" (correction value of the cutting carriage movement direction): 0.00 mm