Prioritizing the Cutting Settings of This Machine over the Software RIP Settings

This setting is used to prioritize the cutting conditions set on the machine over the software RIP settings. You can also make the settings for the cutting conditions in the software RIP, and normally the software RIP settings are given priority.
Procedure
  1. Press [MENU].
  2. Press [▲] to display the following screen.


  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [▶] to display the following screen.


  5. Press [▲] or [▼] to select "MENU".
    Prioritize the cutting conditions set on the machine over the software RIP settings.
    If this is set to "COMMAND", priority is given to the software RIP settings.


  6. Press [ENTER] to confirm your entry.
  7. Press [MENU] to return to the original screen.
    MEMO

    Default setting: "COMMAND"