The media could not be detected automatically. Manually set the printing area.

This message appears when media with high reflectance is set up. Manually set the printing area.

Procedure
  1. Tap OK on the screen displaying the above message.
  2. Tap Change.
    The Set the right edge of the printing area within the area specified by the pinch rollers. screen appears.
  3. Hold down AP-640_Panel_Icon_LEFT to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the left edge of the right pinch roller.

    VG3_MediaWidthSetting_manual_R

  4. Tap OK.
    The Set the left edge of the printing area within the area specified by the pinch rollers. screen appears.
  5. Hold down AP-640_Panel_Icon_LEFT to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the right edge of the left pinch roller.

    VG3_MediaWidthSetting_manual_L

  6. Tap OK.
    The set left and right positions are applied to the Printing Area (Width).
  7. Tap OK.